7/27/2023 0 Comments Sata power pinThe world's first SATA hard disk drive is the Seagate Barracuda SATA V, which was released in Jan 2003. To ensure backward compatibility with legacy ATA software and applications, SATA uses the same basic ATA and ATAPI command sets as legacy ATA devices. In contrast, parallel ATA (the redesignation for the legacy ATA specifications) uses a 16-bit wide data bus with many additional support and control signals, all operating at a much lower frequency. SATA host adapters and devices communicate via a high-speed serial cable over two pairs of conductors. However, the ATA specifications simply use the name "AT Attachment", to avoid possible trademark issues with IBM. "AT" was IBM's abbreviation for "Advanced Technology" thus, many companies and organizations indicate SATA is an abbreviation of "Serial Advanced Technology Attachment". The IBM AT's controller interface became a de facto industry interface for the inclusion of hard disks. The "AT Attachment" (ATA) name originated after the 1984 release of the IBM Personal Computer AT, more commonly known as the IBM AT. The remainder of this article strives to use the SATA-IO terminology and specifications.īefore SATA's introduction in 2000, PATA was simply known as ATA. As with many other industry compatibility standards, the SATA content ownership is transferred to other industry bodies: primarily INCITS T13 and an INCITS T10 subcommittee ( SCSI), a subgroup of T10 responsible for Serial Attached SCSI (SAS). The SATA-IO group collaboratively creates, reviews, ratifies, and publishes the interoperability specifications, the test cases and plugfests. Serial ATA industry compatibility specifications originate from the Serial ATA International Organization (SATA-IO). Revision 1.0 of the specification was released in January 2003. SATA was announced in 2000 in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing protocol. Serial ATA industry compatibility specifications originate from the Serial ATA International Organization (SATA-IO) which are then released by the INCITS Technical Committee T13, AT Attachment (INCITS T13). Serial ATA succeeded the earlier Parallel ATA (PATA) standard to become the predominant interface for storage devices. SATA ( Serial AT Attachment) is a computer bus interface that connects host bus adapters to mass storage devices such as hard disk drives, optical drives, and solid-state drives. Please consider expanding the lead to provide an accessible overview of all important aspects of the article. After booting up the PC and returning to the storage information in the BIOS, we can see that the Western Digital drive is indeed being recognized - and if you boot into Windows or whichever operating system you're using, you will see the drive and be able to partition it and format it.This article's lead section may be too short to adequately summarize the key points. Going back to the computer, while the Kapton tape is on the third pin, connect the power cable which will slip right over the tape, and then the data cable. The tape is too long for the pin, so snip off the excess with some scissors. I highly recommend that you use an ESD wrist strap while you're doing this, as you are touching the contacts of the drive. Next, on the hard drive, locate the third pin, and gently apply the tape. The goal here is to cut a thin strip of tape - enough to cover that third pin - so take a razor and gently slice off a strip of tape. Then take a piece of cardboard and place it underneath. Take a piece of backing paper from a sheet of labels and place the tape onto it. It's a special type of non-conductive tape that's stable at both low and high temperatures, and is yellowish in color. The first solution involves a piece of Kapton tape to cover that third pin.
0 Comments
Leave a Reply. |